THIS MODULATOR IS MADE BY KISAN ELECTRONICS AND IS FULLY TESTED AND COMPATIBLE WITH OUR G18LED, G18LEDH, G158897 AND G159820S PATHFINDERLED LED HEADLIGHT SYSTEM.
PLUG N PLAY DESIGN. SEE INSTALLATION MANUAL BELOW.
New Style P115W-D is
totally self-contained. There are no hidden boxes or switches. There
are no wires to cut or splice. The New Style is is more compact and uses
letest generation electronics.
New Style P115W-D is
designed for a motorcycle with dual 3-pin H4, or a Japanese H7 2-pin
(with p43t expander to plug into H4 socket) headlamps - like GoldWing.
This dual unit has (1) Master and (1)
Slave. Master supplies the modulation pulses to the Slave, so they are
fully synchronized. Each modulator is 1.05 (26mm) round, and requires no
additional room after it's plugged on the back of the bulb because of
the pig-tail design.
LED Headlight Bulbs:
For this Option: Special software program controls the modulation with PWM mode for a "softer" transition.
SELECT appropriate OPTION depending on the type of bulb. Options are not interchangeable!
pathBlazer circuit
modulates the hi-beam current - from 100% ON to about 17% OFF. This is
accomplished by using a p-channel MOSFET, which is inherently safe. The
MOSFET is designed to fail in the ON state. For additional safety, the
circuits DO NOT utilize the lo-beam whatsoever!
MAX power rating is 115 watts. DO NOT EXCEED!


P115W-D comes with a detachable daylight sensor, which plugs into the Master of the pathBlazer. A Sync wire then plugs into the Slave.
The daylight sensor functions as a
switch; it stops modulation when it cannot see enough daylight. Since
the internal circuitry is controlled by a microprocessor, it allows for
customizable features.
Programmable Daylight Sensor
3-Click programming:
If you turn the high beam on and then turn the ignition on (3) times
quickly, the sequence is interpreted as an active command to change the
sensitivity. Software version v.823A allows 8 linear steps between the
high and low end.
The
daylight sensor has a low frequency filter to avoid false triggering.
Please note that florescent lamps may not trigger the sensor - it needs
constant incandescent light.
pathBlazer uses
a soft-switching technique. It throttles the current flow through the
bulb filament, so that there's no "thermal shock" due to a sudden inrush
of current, which can damage the bulb filament or shorten its life
considerably. This is far superior than maintaining a small voltage!
Select
hi-beam to modulate - as long as there's sufficient daylight. If you
enter a tunnel or if it gets dark, it will stop the modulation of the
hi-beam and stay ON steady. Select lo-beam to end modulation.
Installation does not require any
special tools. Everything needed to complete the job is in the product
package. Follow the steps described here and refer to the Installation
Manual enclosed in the product package.
Installation videos for Goldwing
models with standard bulbs and LED bulbs are viewable on our YouTube
channel. Or you can search for them directly on YouTube.
Click here for Installation Manual
link to manufacturer's product info page: https://kisantech.com/mag/pathblazer/p115w-d.html